Topics in Category: ATA 29 Hydraulic Systems - Rotate.Aero http://rotate.aero Wed, 22 Nov 2017 12:42:19 +0000 MYOB /media/kunena/images/icons/rss.png Topics in Category: ATA 29 Hydraulic Systems - Rotate.Aero en-gb ATA 29-11, MD-10-10 Engine Hydraulic Pump Verification - by: Mark http://rotate.aero/forum/ata29-hydraulic-systems-md10/255-ata-29-11-md-10-10-engine-hydraulic-pump-verification#438 http://rotate.aero/forum/ata29-hydraulic-systems-md10/255-ata-29-11-md-10-10-engine-hydraulic-pump-verification#438 ATA 29 Hydraulic Systems Thu, 19 Oct 2017 22:59:57 +0000 ATA 29-12, MD-10-10 Hydraulic Pressure Low - by: Mark http://rotate.aero/forum/ata29-hydraulic-systems-md10/235-ata-29-12-md-10-10-hydraulic-pressure-low#398 http://rotate.aero/forum/ata29-hydraulic-systems-md10/235-ata-29-12-md-10-10-hydraulic-pressure-low#398 non-avoidable discrepancy dealing with the #1 hydraulic pressure. With spoiler handle movement, the pressure on the #1 system was consistently 500-700psi lower than the #2 and #3. This was accompanied by the indication going amber. (The pressures are pretty close in the image below. This is a recovery phase with no spoiler movement and pressures climbing.)



So what could I be dealing with, a bad indication or a bad reversible motor pump? What did I "hope" it was?

There is one quick way to verify the fault in this case. Turn off the electric pumps and crank an engine to be used as a pressure source. The engine does not need fuel applied. The starter alone will fully pressurize the engine driven pump(s).

In the case of this aircraft, with the #1 engine spinning I had 2900psi and it only dropped a hundred pounds while moving the flight controls.

Verdict??? A weak reversible pump and a nasty ass replacement procedure.

There is no way two electrical pumps will ever generate the power of an engine driven pump. With the electric pumps, all the pressures will be low, but not to the level that was noticed with the #1 system. It is also a testament to the strength of the starters.]]>
ATA 29 Hydraulic Systems Mon, 19 Jun 2017 02:53:29 +0000
ATA 29-12, MD-10-10 Hydraulic Pressure Indication - by: Mark http://rotate.aero/forum/ata29-hydraulic-systems-md10/3-ata-29-12-md-10-10-hydraulic-pressure-indication#3 http://rotate.aero/forum/ata29-hydraulic-systems-md10/3-ata-29-12-md-10-10-hydraulic-pressure-indication#3 Not much troubleshooting needed here. Hang a new sensor on the plug. If problem clears, get ready for a possible Skydrol bath (even with head pressure blown, I still received a "goodly" amount of fluid).










MD-10-10 ATA 29-12 Hydraulic Pressure Indication
Schematic Manual 29-10-1
Maintenance Manual 29-12-46-2
Equipment List ID "T2-39"
]]>
ATA 29 Hydraulic Systems Mon, 14 Jul 2014 00:42:51 +0000